MTS FlexTest Models 200 - Manual (Page 187)

Model 494.47 Dual UART/Encoder Interface Card
MTS FlexTest® Models 40/60/100/200 Controller Hardware Mezzanine Cards 187
Incremental Encoder/Counter Pin Assignments for the Model 494.47 Card
Signals are routed to and from the Model 494.47 card through two RJ-50
connectors located on the front of the I/O carrier board. The device type that
you set for the card determines the pin assignments. The following figure
shows the pin assignments for incremental encoders with quadrature outputs.
The front-panel sockets on the I/O carrier board only accept cabling
with 10-pin, shielded, RJ-50 connectors.
The use of other RJ connector types (less than 10 pins or unshielded)
with the I/O carrier board can cause component damage.
Only use cables equipped with 10-pin, braided shielded, RJ-50 connectors
(with gray boot) with the I/O carrier board.
CAUTION
Device 1
Pin 1 + IEEE 1451.4 Class 2
Pin 2 + Enc A [1]
Pin 3 - Enc A [1]
Pin 4 + Power
Pin 5 + Index [1]
Pin 6 - Index [1]
Pin 7 - Power
Pin 8 + Enc B [1]
Pin 9 - Enc B [1]
Pin 10 - IEEE 1451.4 Class 2
1 2 3 4 5 6 7 8
Device 2
Pin 1 + IEEE 1451.4 Class 2
Pin 2 + Enc A [2]
Pin 3 - Enc A [2]
Pin 4 + Power
Pin 5 + Index [2]
Pin 6 - Index [2]
Pin 7 - Power
Pin 8 + Enc B [2]
Pin 9 - Enc B [2]
Pin 10 - IEEE 1451.4 Class 2
RJ-50 Pin Assignments (front view)
1 2 3 4 5 6 7 8 9 10
J1A
J1B
J2A
J2B
J3A
J3B
J4A
J4B
494.47 Dual UART/Encoder
Mezzanine Card
Card Slot 1
uses RJ-50 connectors
J1A and J1B
Card Slot 2
uses RJ-50 connectors
J2A and J2B
Card Slot 3
uses RJ-50 connectors
J3A and J3B
Card Slot 4
uses RJ-50 connectors
J4A and J4B
Model 494.40 I/O
Carrier Board