MTS FlexTest Models 200 - Manual (Page 197)

Model 494.49 Quad Encoder Interface Card
MTS FlexTest® Models 40/60/100/200 Controller Hardware Mezzanine Cards 197
Model 494.49 Quad Encoder Interface Card Connections
Encoder signals are routed to the Model 494.49 card through a Model 493.80
Quad Encoder Transition Board. Transition board connectors J11 and J12
connect to the I/O carrier board RJ-50 connectors.
The front-panel sockets on the I/O carrier board only accept cabling
with 10-pin, shielded, RJ-50 connectors.
The use of other RJ connector types (less than 10 pins or unshielded)
with the I/O carrier board can cause component damage.
Only use cables equipped with 10-pin, braided shielded, RJ-50 connectors
(with gray boot) with the I/O carrier board.
CAUTION
Model 493.80
Encoder Interface Board Model 494.40 I/O Carrier Board
Transition Card Cage VME Card Cage Encoder Inputs
Encoder
Channels
1 and 2
Encoder
Channels
3 and 4
J3
493.80
ADDA
ENCODER
J4
J5
J6
J11
J12
1 2 3 4 5
6 7 8
J1A
J1B
J2A
J2B
J3A
J3B
J4A
J4B
494.49 Quad
Encoder Interface
Mezzanine Card
Encoder
Channel 1
(J3)
Encoder
Channel 4
(J6)
Encoder
Channel 2
(J4)
Encoder
Channel 3
(J5)
J11
J12
Differential
Encoder
Signals
+
Encoder Power
Single-ended
Encoder
Signals