MTS FlexTest Models 200 - Manual (Page 281)

Cables
MTS FlexTest® Models 40/60/100/200 Controller Hardware Cables 281
Chapter 6
Cables
Series 494 Cable Part Numbers
For a complete listing of Series 494 cable part numbers, see the System
Cable/Jumper Plug Guide engineering drawing (part number 700-003-814).
How to Identify Series 494 RJ-50 Connectors
All Series 494 cables equipped with 10-pin RJ-50 connectors have a gray
boot. Do not use cables with black connector boots with Series 494
hardware. Older cables with black boots may use other types of connectors
that can damage the RJ-50 sockets on Series 494 I/O Carrier boards.
The front-panel sockets on the I/O carrier board only accept cabling
with 10-pin, shielded, RJ-50 connectors with a gray boot.
The use of other RJ connector types (less than 10 pins or unshielded
with a black boot) with the I/O carrier board can cause component
damage.
Only use transducer cables equipped with 10-pin, braided shield, RJ-50
connectors (with a gray boot) with the I/O carrier board.
CAUTION