Define the vme slot locations – MTS FlexTest Models 200 User Manual
Page 320
MTS FlexTest® Models 40/60/100/200 Controller Hardware
Aero Multibox Overview
Aero Multibox Systems
320
Define the VME Slot Locations
The Hwi Editor application can detect the hardware in the controller but cannot
detect the exact VME slot where the various VME boards are installed. You must
verify the slot number where each VME board is installed and make changes as
necessary.
Important
I/O carriers should be physically installed (left-to-right) based on
their address settings starting with the lowest address setting.
1. Click Search to detect the hardware installed in the box.
When the Hwi Editor detects the hardware, it shows the processors and then
numbers the rest of the VME boards based on their address settings. Any
gaps in the VME chassis (slots with no hardware installed) are not shown.
2. Where necessary, change the numbers in the Slot column to match the
physical location of the hardware.