MTS FlexTest Models 200 - Manual (Page 65)

Model 494.41 Single-Station System Board
MTS FlexTest® Models 40/60/100/200 Controller Hardware FlexTest Controller Configurations 65
Analog Output Connections for the Model 494.41 System Board
The Model 494.41 System board provides two analog output signals that are
available on the D/A Output connector (located on the rear panel of the Model
494.04 Chassis). Each D/A output is software defined.
Cable specification
To maintain EMC compliance, the D/A Output cable must comply with the
following specifications:
Connector type–9-pin, type D, male EMI connector.
Backshell–EMI metallized plastic or metal.
Cable–shielded twisted pairs (24 AWG minimum), braided shield with the shield
connected to the metallized backshell at the chassis.
Power
100-240 VAC
50-60 Hz, 1-2 A
DA Output
J24
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
J54 Dig In J49
Aux Pwr
J25 Hpu
Dig Out J55 Intlk J43 E-stop J29
J28 HSM
LAN 2 LAN 1
DEBUG MOT
O ROLA
10/100 BASE T 10/100 BASE T
SCSI BUSY PIB BUSY PCI MEZZANINE CARD PCI MEZZANINE CARD
494.04 Chassis
494.41 System
Board
D/A Output
D/A Output
2
6
4
9
Monitor 1
Monitor 2
-
+
D/A Output 1
D/A Output 2
-
+
Twisted
Pairs