MTS FlexTest Models 200 - Manual (Page 72)

MTS FlexTest® Models 40/60/100/200 Controller Hardware
Model 494.42 Single-Station System Board
FlexTest Controller Configurations 72
J23 E-Stop/Run Output Connections for the Model 494.42 System Board
The Model 494.42 System Board provides E-Stop/Program Run outputs that are
available on the J23 E-Stop/Run connector.
Cable specification
To maintain EMC compliance, the J23 E-Stop/Run cable must comply with the
following specifications:
Connector type–9-pin, type D, male EMI connector.
Backshell–EMI metallized plastic or metal.
Cable–4-conductor with braided shield, with the braid connected to a metallized
plastic backshell at the chassis.
E-Stop 1 Output (NO)
HPU E-Stop = Open
494.42 System Board
J23 Estop/Run
E-Stop 2 Output (NO)
HPU E-Stop = Open
Program Run 1 Output (NC)
Program Run = Open
Program Run 2 Output (NO)
Program Run = Closed
Reserved
J23
Estop/Run
1
2
3
4
5
7
6
8
9
Power
100-240 VAC 50-60 Hz, 1-2 A
DA Output
J24
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
LAN 2 LAN 1
DEBUG MOT OROLA
10/100 BASE T 10/100 BASE T
SCSI BUSY PIB BUSY PCI MEZZANINE CARD PCI MEZZANINE CARD
J54
Dig In
J55 Dig Out
J43 INTLK
J56 UPS
J49
Aux Pwr
J23 Estop/Run
J29 Load Frame
J25 HPU
J28 HSM
Reserved