MTS FlexTest Models 200 - Manual (Page 85)

Model 494.44 Two-Station System Board
MTS FlexTest® Models 40/60/100/200 Controller Hardware FlexTest Controller Configurations 85
Model 494.44 System Board Specifications
Model 494.44 Specifications (part 1 of 3)
P ARAMETER S PECIFICATION
HSM Control*
Off/Low/High
Control
Low Output
High Output
Proportional
Control
Signal Output
Solenoid
Impedance
Ramp Time
(0 to full scale)
Connector J28A and 28B (D-15S)
+24 V DC, 1.0 A maximum
+24 V DC, 1.0 A maximum
0–0.78 A
20– 25 Ω
2.1 s or 4.2 s (software selectable)
* The type of HSM control (off/low/high or
proportional) is software configurable.
E-Stop/Run
Output Relay
Voltage
Current
Connector J23 (D9S)
30 V DC/AC maximum
1 A maximum
Two (2) Normally Open Relay Contacts:
HPU E-Stop = Open
Normally Open Relay Contacts:
Prog. Run = Closed
Interlock Output
Relay
Voltage
Current
Connector J43 A/B(D9S) (one per J43 connector)
30 V DC/AC maximum
1 A maximum
Normally Open Relay Contacts: Open = Interlock
Normally Closed Relay Contacts: Closed = Interlock