MTS FlexTest Models 200 - Manual (Page 98)

MTS FlexTest® Models 40/60/100/200 Controller Hardware
Model 494.44 Two-Station System Board
FlexTest Controller Configurations 98
J55 Digital Output Connections for the Model 494.44 System Board
Connector J55 Dig Out provides eight digital outputs that must be used with the
Model 494.32 8-Channel High-Current DI/O Breakout Box. The breakout box
provides high-current switching/isolation and device connections for each of the
eight J55 outputs.
Note External power for the output devices is brought into the breakout box
through breakout-box connector J29.
Cable specification
To maintain EMC compliance, the J55 Digital Output cable must comply with
the following specifications:
Connector–9-pin contact type D male EMI connector
Back shell–EMI metallized plastic
Cable–AWG and number of conductors as required. Braided shield with shield
connected to the metallized backshell at the chassis.
DO 1
DO 1
DO 1
DO 1
DO 1
DO 1
DO 1
DO 1
DO 1
494.44 System Board 494.32 Breakout Box
J55 Dig Out J20 Outputs
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
Power
100-240 VAC 50-60 Hz, 1-2 A
DA Output
J24
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
LAN 2 LAN 1
DEBUG MOT OROLA 10/100 BASE T 10/100 BASE T SCSI BUSY PIB BUSY PCI MEZZANINE CARD PCI MEZZANINE CARD
J55 Dig Out
Dig In J54
J43A
J43B
J49
Aux Pwr
Estop/Run J23 Interlock
J29A
J29B
Load Frame
J28 HSM
A-B
HPU J25
J55 Dig Out