MTS Nut Grips - Manual (Page 19)

MTS Fundamental™ Bolt Grips and Nut Grips Installation 19
F-JLL305A1
F-JLL305A2
Install the upper assembly according to actions shown in Figure 6.
Figure 6 Installation Procedure of Upper Assembly
1. Pick out two wedge faces which have the same marks, and mount one
wedge face into the upper grip as per ① and lock it with the baffle-board.
2. Mount another wedge face into the upper grip as per ② and lock it with the
baffle-board.
3. Mount the upper assembly on the square nut as per ③, ④. Make the column
of the upper joint touch the surface of the V-shape groove of the wedge
faces.
4. Close the upper grip.
5. Use similar steps to install the lower assembly to the lower grip.
Upper Crosshead Baffle-Board Cushion Plate