Mounting for angularly applied loads, Mounting for angularly applied loads 26 – MTS Series 249 Swivels User Manual
Page 26
Series 249 Rod Swivel Product Manual
26
Mounting for Angularly Applied Loads
Installation
Mounting Bolt Tightening Sequence
Mounting for Angularly Applied Loads
If the swivel mounting surface is not perpendicular to the direction of applied
force, it may be necessary to install retaining stops to prevent the swivel from
slipping. Slippage can be expected if the operating forces for the angle of load
application are exceeded.
The following figure shows the position of the retaining stops and the angle of
load application.
Different system configurations require the use of different types of retaining
stops. In all cases, the retaining stops must withstand a shear force equal to or
greater than the forces specified in the following chart.
Retaining
Stops
Retaining
Stops