Barco MFGD 2320 - Manual (Page 9)

User manual MFGD 2320 8
2. INSTALLATION
2.1. Precautions
• Keep your original packaging. It is designed for this display and is
the ideal protection during transport.
• Avoid reflections in the flat panel to reduce eye strain.
• Place the display on a strong and stable table or desk.
• Keep the display away from heat sources and provide enough
ventilation in case it is built in a rack or console.
• Make sure all equipment is switched off before connecting the
signals.
2.2. Before installing the display
Important:
In the factory, the height-positioning system in the display foot is
blocked with a strap to prevent damage during transportation.
Before installing the display, you must remove this strap.
Strap
To remove the strap:
1 Position the display with its rear side facing you.
2 Lift up the 2 clips of the foot cover to release the cover from the
foot.
3 Pull the lower side of the cover towards you and simultaneously
slide the cover downward.
4 Pull the red strap out of the fixation holes in the foot.
You can better leave the cover off the foot while connecting the signal
cables to the display.