MTX Audio MUD100-2 200W RMS 2-Channel Power Sports Amplifier - Manual (Page 2)

M T X . C O M 2
PRODUCT INFORMATION
Model #
Serial #
Dealer’s Name
Date of Purchase
INTRODUCTION
Thank you for purchasing this MTX Audio Hi-Performance amplifier. Proper installation matched
with MTX speakers and subwoofers provide superior sound and performance for endless hours of
enjoyment whether you are waking the neighbors or just out enjoying your tunes. Congratulations
and enjoy the ultimate audio experience with MTX!
FEATURES
• Compact Size
• Double Sided PCB
• Surface Mount Components
• MOSFET Design
• LPF and HPF Crossover
• Noise Free Design
CONTROL FUNCTIONS
1. Wiring Harness - All wiring to the amplifier will run through the wiring harness.
Speakers - Connect speakers/subwoofers to these terminals. Be sure to check wire for proper
polarity. Never connect the speaker cables to the chassis ground.
+BATT (+12 Volt Power) - Connect this terminal through a FUSE or CIRCUIT BREAKER to the
positive terminal of the vehicle battery or the positive terminal of an isolated audio system
battery. WARNING: Always protect this power cable by installing a fuse or circuit breaker of the
appropriate gauge within 18 inches (45cm) of the battery terminal connection.
Remote Turn On - This terminal turns on the amplifier when (+) 12 volt is applied to it. Connect it to
the remote turn on lead of the head unit or signal source.
GND - Connect this cable directly to the frame of the vehicle. Make sure the metal frame has
been stripped of all paint down to the bare metal. Use the shortest distance possible. CAUTION:
Do not connect this terminal directly to the vehicle battery ground terminal or any other factory
ground points.
RCA Input Jacks - This unit is designed to function with source units that feature RCA outputs. If
your source unit does not have RCA outputs you will need to use a high to low level converter.
Do not connect this amplifier directly to the speaker level outputs of the source unit, damage to
the amplifier will occur. A source unit with a minimum level of 200mV is required for proper
operation.
2. Gain Control - The Gain control will match the amplifier’s sensitivity to the source units signal
voltage. The operating range is 5V to 200mV. NOTE: This is NOT a volume control.
3. X-Over Mode and Frequency Control (Full Range) - These controls allow control over the
frequencies played. There is an option for Low Pass, Full Range, or High Pass. In LP or HP mode,
the crossover frequency will be set at 80Hz.