Purenex Multipure Aquamini - Manual (Page 7)

7
2.3: Installing the New Filter
turn to
remove
turn to
connect
1. If you have not done so already, remove the plastic wrapper and instruction wrap from
around the new filter.
2. Align the threaded hole of the new filter cartridge onto the inside thread of the top half
of the Dws. rotate the cartridge clockwise to tighten (if facing the inside of the top half
of the housing). Make sure that the cartridge is threaded properly and straight. DO nOT
OVerTIGHTen.
3. reconnect the top half of the housing (with attached filter cartridge) with the bottom
half. replace the locking V-Band, making sure the screw is in place to connect the
band together.
4. screw the black knob onto the locking V-Band, turning it clockwise to tighten.
5. Make sure that the V-Band is tightly secured evenly around the housing top and bottom.
6. Proceed to 1.3: Preparing and Operating Your Drinking water system to complete the
installation.
2.4: Flushing / Disinfecting the System
3.1: Warranty
Multipure recommends that you do not allow water to sit in the system for extended periods of time without use. If a unit is
left unused for more than 10 days, it may need to be flushed/disinfected before resuming normal use.
To disinfect the system:
1. with the faucet off, press the right button on the diverter valve to select the filtered water spout and allow water to flow
out of the Dws.
2. when the flow of water stops, press the left button on the diverter valve.
3. remove the filter by following the directions in 2.2: removing the Old Filter.
4. Add 5 to 7 drops of bleach to the bottom half of the housing.
5. reconnect the top half of the housing without a replacement filter installed.
6. Turn on the water supply and allow the system to fill up with the water/bleach solution.
7. Turn on the faucet, and press the right button on the diverter valve to select the filtered water spout.
8. Once water begins to flow, press the left button to stop the filtered water spout.
9. Turn off the faucet, and let the system soak for at least 30 minutes.
10. After 30 minutes, with the faucet off, press the right button on the diverter valve to select the filtered water spout and
flush the water and bleach out of the system.
11. when the flow of water stops, open, clean, and rinse out the inside of the system housing.
12. Proceed to 2.3: Installing the new Filter to install the new filter.
Multipure 90-Day Guarantee: Multipure is confident in the performance of its Drinking water systems (Dws). If you
should find this Drinking water system unsatisfactory, let us know within 90 days of purchase for a prompt exchange or
refund.
Multipure Warranty: Multipure warrants to the original retail customer its Dws and components to be free of defects in
material and workmanship for use under normal care, and will repair or replace any system at no charge (excluding trans-
portation to Multipure Corporate Headquarters) to the customer during the warranty period. The Dws housing is warranted
for a lifetime (provided the filter has been changed at least once per year); all exterior hoses and attachments to the Dws
are also warranted for defects in material and workmanship for one (1) year.
Multipure solid Carbon Block Filters are warranted for defects in material and workmanship for use under normal care. The
capacity of the filter cartridge depends upon the amount of impurities in the water to be processed.
except as otherwise expressly provided above, Multipure makes no warranties, express or implied, arising by law or other-
wise, including without limitation the implied warranties of merchantability and fitness for a particular purpose, to any per-
son. This limited warranted may not be altered, varied, or extended except by a written instrument executed by Multipure.
The remedy of repair or replacement as provided under this limited warranty is exclusive. In no event shall Multipure be
liable for any consequential or incidental damages to any person whether occasioned by negligence of the manufacturer,
including without limitation damages of loss of use, cost of substitution, property damage, or other monetary loss.
warranty is valid only if the Dws is operated within conditions listed herein. The warranty begins from the date of purchase.
3 Additional Information