Multiquip MT62HS - Manual (Page 9)

MT-62HS — PARTS & OPERATION MANUAL — REV. #2 (12/15/03) — PAGE 9
MT-62HS — RULES FOR SAFE OPERATION
Emergencies
■ ALWAYS know the location of the nearest
fire extinguisher .
■ ALWAYS know the location of the nearest and
first aid kit .
■ In emergencies always
know the location of the
nearest phone or keep a phone on the job site .
Also know the phone numbers of the nearest
ambulance , doctor and fire department . This
information will be invaluable in the case of an
emergency.
Maintenance Safety
■ NEVER lubricate components or attempt service on a running
rammer.
■ ALWAYS allow the rammer a proper amount of time to cool
before servicing.
■ Keep the rammer in proper running condition.
■ Fix damage to the rammer immediately and always replace
broken parts.
■ Dispose of hazardous waste properly. Examples of potentially
hazardous waste are used motor oil, fuel and fuel filters.
■ DO NOT use food or plastic containers to dispose of
hazardous waste.
■ NEVER use accessories or attachments, which are not
recommended by Multiquip for this equipment. Damage to
the equipment and/or injury to user may result.
■ Whenever necessary, replace nameplate, operation and
safety decals when they become difficult read.
■ NEVER Run engine without air filter. Severe engine may
occur. Service air filter frequently to prevent carburetor
malfunction.
■ AVOID wearing jewelry or loose fitting clothing that may snag
on the controls or moving parts, this can cause a serious
injury.
■ ALWAYS check to make sure that the operating area is clear
before starting the engine.
■ NEVER leave the machine
unattended while running.
■ ALWAYS be sure the operator is familiar with proper safety
precautions and operations techniques before using rammer.
■ ALWAYS read, understand, and follow procedures in
Operator’s Manual before attempting to operate equipment.
■ ALWAYS store equipment properly when it is not being used.
Equipment should be stored in a clean, dry location out of the
reach of children.
■ Refer to the ROBIN Engine Owner's Manual for engine
technical questions or information recommended by Multiquip
for this equipment. Damage to the equipment and/or injury to
user may result.
Transporting
■ ALWAYS shutdown engine before transporting.
■ Tighten fuel tank cap securely and close fuel cock to prevent
fuel from spilling.
■ Drain fuel when transporting rammer over long distances or
bad roads.
■ When placing the rammer inside a truck-bed for transport,
always tie-down the rammer.
■ ALWAYS use proper lifting techniques when moving the
rammer.