Multiquip SDW225SS - Manual (Page 6)

PAGE 6 —SDW-225SS WELDER/GENERATOR— OPERATION & PARTS MANUAL — REV. # 2 (10/07/05)
SDW-225SS — SAFETY MESSAGE ALERT SYMBOLS
Safety precautions should be followed
at all times when operating this
equipment. Failure to read and
understand the Safety Messages and
Operating Instructions could result in
injury to yourself and others.
FOR YOUR SAFETY AND THE SAFETY OF OTHERS!
This Owner's Manual has been developed to provide complete
instructions for the safe and efficient operation of the MQ Model
SDW-225SS
Welder/Generator. Refer to the engine
manufacturer's instructions for data relative to its safe operation.
SAFETY MESSAGE ALERT SYMBOLS
The three (3) Safety Messages shown below will inform you
about potential hazards that could injure you or others. The
Safety Messages specifically address the level of exposure to
the operator, and are preceded by one of three words: DANGER,
NOTE
You WILL be KILLED or SERIOUSLY INJURED
if you DO NOT follow these directions.
You CAN be INJURED if you DO NOT follow
these directions.
CAUTI CAUTI CAUTI CAUTI CAUTION
DANGER DANGER DANGER DANGER DANGER
Lethal Exhaust Gases
HAZARD SYMBOLS
Potential hazards associated with the operation of this
equipment will be referenced with Hazard Symbols which
appear throughout this manual, and will be referenced in
conjunction with Safety Message Alert Symbols.
Engine exhaust gases contain
poisonous carbon monoxide. This gas
is colorless and odorless, and can
cause death if inhaled. NEVER operate
this equipment in a confined area or
enclosed structure that does not provide
ample free flow air.
Diesel Fuel is extremely flammable,
and its vapors can cause an explosion
if ignited. DO NOT start the engine near
spilled fuel or combustible fluids.
DO NOT fill the fuel tank while the engine is running or
hot. DO NOT overfill tank, since spilled fuel could ignite if
it comes into contact with hot engine parts or sparks from
the ignition system. Store fuel in approved containers, in
well-ventilated areas and away from sparks and flames.
Engine components can generate extreme
heat. To prevent burns, DO NOT touch
these areas while the engine is running or
immediately after operations. Never
operate the engine with heat shields or heat
guards removed.
ALWAYS wear approved respiratory
protection when required.
Lethal Exhaust Gas Hazards
WARNING WARNING WARNING WARNING WARNING
Explosive Fuel Hazards WARNING WARNING WARNING WARNING WARNING
Burn Hazards
WARNING WARNING WARNING WARNING WARNING
Respiratory Hazards
WARNING WARNING WARNING WARNING WARNING
Before using this welder/generator,
ensure that the operating individual
has read and understands all
instructions in this manual.
You CAN be KILLED or SERIOUSLY INJURED if
you DO NOT follow these directions.
WARNING WARNING WARNING WARNING WARNING