Multiquip WM45HCE_rev_0 - Manual (Page 23)

WM45HCe pLaSTeR MORTaR MIXeR • OpeRaTIOn and paRTS ManuaL — Rev. #0 (02/04/13) — page 23
trOubleshOOtinG (enGine/Mixer)
Troubleshooting (Mixer)
Symptom possible problem Solution
Blades will not rotate.
Worn or defective main gear?
Check main gear. Replace if worn or
broken.
Worn or defective pinion gear?
Check pinion gear. Replace if worn or
broken.
Material load too heavy, exceeding
mixer capability?
Reduce amount of material being
mixed.
Object stuck inside mixing drum,
jamming paddle rotation?
Stop engine. Empty out drum
contents. Remove obstruction.
Improper engine speed? Check and adjust engine speed.
Material leaking from drum ends. Worn or defective paddle shaft seals? Replace seals.
Drum diffi cult to discharge (tilt).
Defective or worn drum support
brackets?
Apply grease to bracket or replace.
Blades adjusted too tight.
Adjust blades until they almost touch
side walls of drum.