Multiquip MC3SBA - Manual (Page 9)

MIX N' GO MIXER — OPERATION AND PARTS MANUAL — REV. #3 (09/20/11) — PAGE 9
SAFETY INFORMATION
FUEL SAFETY (GASOLINE MODELS ONLY)
DANGER
„ DO NOT add fuel to equipment if it is placed inside truck
bed with plastic liner. Possibility exists of explosion or
fire due to static electricity.
„ DO NOT start the engine near spilled fuel or combustible
fluids. Fuel is extremely flammable and its vapors can
cause an explosion if ignited.
„ ALWAYS refuel in a well-ventilated area, away from
sparks and open flames.
„ ALWAYS use extreme caution when working with
flammable liquids.
„ DO NOT fill the fuel tank while the engine is running
or hot.
„ DO NOT overfill tank, since spilled fuel could ignite if it
comes into contact with hot engine parts or sparks from
the ignition system.
„ Store fuel in appropriate containers, in well-ventilated
areas and away from sparks and flames.
„ NEVER use fuel as a cleaning agent.
„ DO NOT smoke around or near the
equipment. Fire or explosion could result
from fuel vapors or if fuel is spilled on a
hot engine.
FUEL
FUEL
GENERATOR SAFETY
If using a generator to power mixer, refer to
applicable generator manual safety information
section.
ELECTRIC MOTOR SAFETY
(ELECTRIC MODELS ONLY)
NOTICE
„ Operate electric motor only at the specified voltage
indicated on the nameplate.
„ DO NOT spray water onto electric motor.
„ ALWAYS disconnect AC power plug from power source
before moving mixer.
„ ALWAYS make sure the ON/OFF switch
on the electric motor is in the OFF position
when not in use and before inserting the
mixer’s power plug into an AC receptacle.
Power Cord/Cable Safety
DANGER
„ NEVER let power cords or cables lay in water.
„ NEVER use damaged or worn cables or cords when
connecting equipment to generator. Inspect for cuts in
the insulation.
„ NEVER grab or touch a live power
cord or cable with wet hands. The
possibility exists of electrical shock,
electrocution or death.
„ Make sure power cables are securely connected.
Incorrect connections may cause electrical shock and
damage to the mixer.
CAUTION
„ Ensure that cables and cords will not be tripped over or
trapped underneath the mixer.
NOTICE
„ ALWAYS make certain that proper power or extension
cord has been selected for the job.