Multiquip WM120SM Series - Manual (Page 13)

WM120PM/SM — OPERATION AND PARTS MANUAL — REV. #7 (09/15/11) — PAGE 13
WM-120P/S — TOWING
NOTE
Before towing, check with local and state laws for proper
compliance.
The tow bar and chain must be properly attached to the mixer
and towing vehicle prior to towing. Refer to the following
installation instruction:
Step 1.
Insert the Draw Bar into the main frame. Secure, utilizing the 3/4"
bolt (grade 5) and nylock nut. Tighten to 100 foot pounds.
DRAW BAR
BOLT & NUT
STEP 1
CONNECTOR LINK
FRAME ANGLE
FRAME GUSSET
INSERT CHAIN THROUGH
THE HOLE STEP 2
DRAW BAR
Step 2.
Install the chain through the hole located between the frame
gusset and frame angle. Loop the chain together and place under
the Draw Bar. Secure with connector link.
VEHICLE
CONNECTOR LINK
DRAW BAR
BOTTOM CONNECTOR LINK
REMOVE EXCESS
CHAIN (SLACK)
STEP 3
NOTE
It is critical that the length of the chain be properly
adjusted, to prevent the
Draw Bar and the front mixer
stand from dropping to the ground (contact) in the event
the Draw Bar becomes disconnected from the towing
vehicle.
If a new safety chain is required use P/N 13363. For a new
connector link use P/N 01004.
Step 3.
Extend the chain along the length of the Draw Bar, remove excess
chain (slack) and secure to bottom connector link. Secure the
chain to the towing vehicle, using the connector link.
CAUTION:
■ Check the following before towing:
BALL HITCH COUPLER
1. Check vehicle hitch, ball, and coupler for signs of wear or
damage. Replace any parts that are worn or damaged
before towing.
2. Use only the 2" ball diameter as indicated on your coupler.
Use of any other ball diameter will create an extremely
dangerous condition which can result in separation of the
coupler and ball or ball failure.
3. Be sure the coupler is secured to the hitch ball and the lock
lever is down tight and locked.
Recheck tightness again after towing about 50 miles.
4. Check that trailer safety chains are properly connected.