Multiquip MS20E - Manual (Page 26)

PAGE 26 — MQ STOW MS20H/MS20E MIXER — PARTS & OPERATION MANUAL — REV. #3 (08/10/06)
MS20H/MS20E MIXER — INITIAL START-UP
4. Turn the engine switch (Figure 15) to the ON position.
Figure 15. Engine ON/OFF Switch
5. Located on the engine cover is the main start/stop switch
(Figure 16). Pull this switch outward to start the engine.
Figure 16. Start/Stop Switch (gasoline)
6. Place the belt slip lever (Figure 17) in the START/STOP
position.
Figure 18. Belt Slip Lever
(Start/Stop Position)
CAUTION:
Make certain the drum lock pin (Figures 18
and 19) is placed to the right (when viewing
the mixer from the towpole end) of the drum
stop block which is welded to the front side of
the drum. Also make sure lock pin is fully
engaged (locked). This will prevent the drum
from tipping.
7. Pull the starter grip (Figure 20) lightly until you feel
resistance, then pull briskly. Return the starter grip gently.
Figure 20. Starter Grip
Figure 19. Drum Lock Pin (Right Position)
Figure 19. Drum Lock Pin (Side-View)