Dm15a9c/cdm2csa — pre-setup – Multiquip CDM2CSA User Manual
Page 20
PAGE 20 —DM15A9C/CDM2CSA — OPERATION AND PARTS MANUAL — REV. #1 (11/09/05)
DM15A9C/CDM2CSA — PRE-SETUP
Attaching the Core Drill Motor to the Cradle
1. There may be an aluminum adapter plate (Figure 17)
attached to the core drill motor. Remove this plate using
a 6 mm allen wrench before attempting to secure the drill
motor to the cradle. This adapter plate is intended to be
used on other MQ drill rig stands.
2. The core drill motor can be secured to the cradle (Figure 17)
by means of 4 retaing screws and lock washers. Use a
6 MM allen wrench to tighten the screws. Make sure to
align the woodruff key on the drill base with the slot on
the cradle.
3. The core drill motor is very heavy and with the added
weight of the drill bit makes it even heavier. When
mounting the drill motor to the cradle assembly,
always
use 2 people.
Figure 17. Attaching the Core Drill Motor to the Cradle
Connecting Water to the Core Drill
1. Attach the supplied water hose and garden hose fitting to the
core drill as shown in Figure 18. Be sure to place worm-
clamps on each end of the hose to prevent leaking.
Figure 18. Connecting the Water
Applying Power to the Core Drill
1. This core drill requires 115 VAC, 60 Hz power. Applying
power to the drill that is not specified will cause severe
damage to the core drill. Always read serial plate tag
before applying power to the core drill.
2. The power plug on this core drill is a 3-prong grounded
type plug. ALWAYS connect this plug to a 3-prong
grounded receptacle. NEVER plug this device into a 2-
prong type receptacle. This will defeat the ground circuit.
The use of a 3-prong to 2-prong adapter is strictly
prohibited.
3. Connect the core drill's AC power cord to a 115 VAC wall
receptacle (Figure 19) that is protected by a 20 amp
circuit breaker. For best results connect the power cord
to a GFCI receptacle.
To avoid accidental starting, ALWAYS
keep fingers away from the power OFF/
ON switch when applying power.
Warning - Accidental Starting
Figure 19. Connecting the Power