Multiquip RCC130H - Manual (Page 47)

RCC130H-CRACK SAW OPERATION AND PARTS MANUAL REV #1 (11/18/04) PAGE 47
OPERATOR HANDLE ASSY.
OPERATOR HANDLE ASSY.
NO. PART NO. PART NAME QTY. REMARKS
1 29022-017 HANDLE, OPERATOR 1
2 29022-018 CRANK SCREW 1
3 29020-030 KNOB 1
4 29020-031 SCREW, HEIGHT ADJUSTMENT 1
5 29022-019 BEARING 2
6 06503-012 SCREW, CAP ½-13 UNC X 1-1/2” PLATED GRD 5 4
7 08233-006 NUT, NYLOC 3/8”-16 UNC, PLATED 4
8 07594-024 PIN, ROLL 3/16” X 1-1/2” 1
9 29022-020 LEVER 1
10 29022-021 BUSHING 4
11 29022-022 HINGE W/BELLEVILLE 2
12 29022-023 WASHER, BELLEVILLE 5/8” 2
13 08297-010 NUT, SELF-LOCKING 5/8-18 UNF, PLATED 1
14 07030-008 WASHER, FLAT ½”, PLATED 4
15 29022-024 SHAFT, OVER CENTER 1
16 06501-008 SCREW, CAP 3/8-16 UNC X 1,PLATED GRADE 5 4
17 29022-025 SCREW, CAP 3/8-16 UNC X 3-3/4” STAINLESS 1
18 07033-006 NUT, 3/8-16 UNC, PLATED 1
19 29022-026 TUBE, BEARING 1
20 18982-010 NUT, 5/8-11 UNC,LH PLATED 2
21 14821-004 CLAMP, HOSE 1-4” 1
22 29020-034 BOOT, RUBBER 1
23 29020-035 BARREL, ADJUSTING 1
24 06922-004 NUT, JAM 5/8-18 UNF, LH PLATED 1
25 06505-048 SCREW, CAP 5/8-11 UNC X 6” PLATED, GRD 5 1
26 07033-010 NUT, HEXAGON 5/8-11 UNC, PLATED 1
27 07030-010 WASHER, FLAT 5/8” PLATED 2
28 29020-036 ROD END, MALE 1
29 29022-027 WASHER, PLASTIC 2
30 29019-013 WASHER, FLAT 5/8” SPECIAL PLATED 1
31 08233-008 NUT, NYLOC ½-13 UNC, PLATED 4
32 CS8-0350 KILL SWITCH/ CABLE 1
34 CS8GH-0370 WIRE LOOM, SHUT-OFF 1
35 CS8-0390 T-TAP, 22-18 GUAGE WIRE 1
36 CV-0411 CLAMP, PLATED 1
37 07029-008 WASHER, LOCK 1/4” 1
38 07030-008 WASHER FLAT 1/4” 1
39 06499-006 HHCS, 1/4”-20 X 3/4” UNC PLATED GRADE 5 1