B&K AVR317 - Manual (Page 72)

68
Link Zone 2 (B) input to Zone 1 (A) input selection - Zone 2 (B) input source selection may be linked with Zone
1 (A) source selections. In operation, whenever a source selection is detected (remote, front panel or RS-232) on
Zone 1 (A), source linkage will cause the source to be selected on both zones. Independent source selection is
still available with Zone 2 (B) remote control, but any Zone 1 (A) source selection supersedes the previous Zone 2
(B) selection.
From Remote From Front Panel Action
1 À(PAUSE) or §(STOP) (UP) or (DOWN) move to Link Input to Zone 1 (A)
2 ¶ (REW) or • (FF) VOLUME KNOB set to Yes or No
Link Zone 2 (B) power to Zone 1 (A) power - Zone 2 (B) power On/Off may be linked to Zone 1 (A). In
operation, whenever power is set to On in Zone 1 (A) the power linkage feature will cause power to be set
accordingly on Zone 2 (B). Zone 2 (B) Independent power on/off is still operational with the Zone 2 (B) remote
control, but any Zone 1 (A) power command supersedes the previous Zone 2 (B) power on/off.
From Remote From Front Panel Action
1 À(PAUSE) or §(STOP) (UP) or (DOWN) move to Link Power to Zone 1 (A)
2 ¶ (REW) or • (FF) VOLUME KNOB set to Yes or No
3 MENU MENU return to ADVANCED SYSTEM SETUP
ADVANCED ZONE B SETTINGS
1 Level Control Variable
2 Maximum Level +15 dB
3 Zone ID 2
4 V2 Output Tape
5 Link Input to Zone A No
6 Link Power to Zone A No
next item adjust
MENU advanced setup
5 Link Input to Zone A No
ZB LINK SRC NO
ADVANCED ZONE B SETTINGS
1 Level Control Variable
2 Maximum Level +15 dB
3 Zone ID 2
4 V2 Output Tape
5 Link Input to Zone A No
6 Link Power to Zone A No
next item adjust
MENU advanced setup
6 Link Power to Zone A No
ZB LINK PWR NO