Multiquip LT12P - Manual (Page 7)

LT12 SERIES LIGHT TOWER • OPERATION MANUAL — REV. #12 (01/20/09) — PAGE 7
SAFETY INFORMATION
NEVER

remove safety pin or pull mast locking pin while
tower is in a raised position!
CHECK  the mast and winch cables for wear. If any
problem occurs when lower or raising the tower,
STOP immediately! Contact a trained technician for
assistance.
NEVER

pivot or retract mast while unit is operating.
NEVER

use the light tower mast as a crane. DO NOT
lift anything with the mast.
NEVER  attach anything to the light tower mast.
ALWAYS  lower the light tower when not in use, or if high
winds or electrical storms are expected.
NOTICE
ALWAYS

keep the immediate area surrounding the light
tower clean, neat, and free of debris.
ALWAYS  keep the machine in proper running condition.
Fix damage to machine and replace any broken parts 
immediately.
ALWAYS

store equipment properly when it is not being
used. Equipment should be stored in a clean, dry location
out of the reach of children and unauthorized personnel.
To prevent the light tower from overturning,  NEVER use
in winds that exceed 65 mph (105 kph).
LAMP SAFETY
WARNING
NEVER

attempt to replace lamp with the power on.
Always shut down the engine or turn off circuit breakers
when changing the lamp.
ALWAYS  allow a suffi cient amount of time for the lamp to
cool before touching or changing. The possibility exists of
severe burns.
CAUTION
NEVER  use force when installing the lamp. Excessive force
could cause the lamp to break, causing bodily harm.
NOTICE
NEVER

leave any grease or oil residue on lamp surface
when replacing or removing lamp. This can create hot
spots, reducing the service life of the lamp.
ALWAYS  make sure lamp surface is clean and dry.
ALWAYS  replace with MQ recommended type lamp.
ALWAYS

have a trained technician install and remove
a fl oodlight, or replace any damaged fi xture wiring.