Briggs & Stratton 20289 - Manual (Page 12)

12
Section 4: Operation
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your spray gun, nozzle extension and quick connect
spray tips.There is also a hook at the front of the
accessory tray to hold your high pressure hose.
NOTE: The extra hole in the tray is for storing a utility
brush.The extra clip in the tray is for storing a turbo
nozzle.The brush and turbo nozzle are NOT included with
your pressure washer.You can buy these items as optional
accessories.
1.
Place nozzle extension through hole on accessory tray,
as shown in Figure 13.
2. Place spray gun through hole on accessory tray on
right side of unit (Figure 13).
NOTE: You may also use the hooks attached to the base
and handle to store your gun and nozzle extension, as
shown on page 6.
3. Insert multi–colored quick connect spray tips in holes
on accessory tray as shown in Figure 13.
4. Hang high pressure hose on hook attached to
accessory tray on front of tray, as shown in Figure 13.
How to Use Quick Connect Spray
Tips
The quick–connect on the nozzle extension allows you to
switch between four different quick connect spray tips.The
spray tips vary the spray pattern as shown (Figure 14).
Follow these instructions to change spray tips:
1. Engage trigger lock on spray gun.
Figure 13 — Typical Accessory Tray
• NEVER exchange spray tips without locking the trigger lock
on the spray gun.
• DO NOT twist spray tips while spraying.
A pressure washer produces a high pressure spray
which increases risk of injury and damage to unit.
CAUTION
40° White
1650 PSI
2.2 GPM
15° Yellow
1950 PSI
2.1 GPM
0° Red
2200 PSI
1.9 GPM
Black
Use to apply
detergent
Figure 14 — Spray Tip Spray Patterns
Low Pressure
High Pressure