One for All SV 1730 Wireless 5.8 Ghz TV Sender - Manual (Page 5)

6
- This product should only be used with the AC power adapters
included or a type that complies with safety standard EN60065 and
that has the following specification: 12 / 250 mA.
- This product should not be exposed to high temperatures.
- This product should not be used in damp places or close to water.
- The AC power adapters should only be connected to a power supply
of 220-240 VAC / 50Hz.
- This product should not be covered.
- Inadequately protected or sensitive electronic equipment may be
affected by the use of this product. This interference can lead to
damage to either equipment. Before you start, please check whether
or not this product can affect surrounding equipment.
Note that the antennas cannot rotate freely over 360º, when
resistance is felt stop rotating otherwise you will damage the
unit permanently.
Safety Precautions
The following paragraphs contain a few examples.
EXAMPLE 1:
Play video on the PVR (source) in the living room and watch
the picture on the TV (destination) in the bedroom.
Connect the TRANSMITTER to the PVR and the RECEIVER to the TV in the
bedroom. Switch on the video and insert a tape. Place the IR eye on / in
front of the IR receiver of the PVR. Switch on the TV in the bedroom.
Select the mode on the TV for “Line In” (AV, EXT or channel 0). Aim the
PVR remote control to the RECEIVER unit and press play. The video should
start playing and picture and sound should appear on your bedroom TV
screen.
EXAMPLE 2:
Also, if you do not have coax cable connection with the TV in
the bedroom, the AV Sender gives the possibility to view your
Satellite Receiver (source) programs also on the TV (destination)
in the bedroom.
You probably already tuned in the channels on your Satellite Receiver. If
not, you may need the manual of your Satellite Receiver to tune in the TV
channels. Once all channels are tuned in, you are able to watch your TV
channels through your AV channel (or other output channel). Connect the
TRANSMITTER to the Satellite Receiver and the RECEIVER to the TV in the
bedroom. Switch on the Satellite Receiver. Place the IR eye on / in front of
the IR receiver of the Satellite Receiver. Switch on the TV in the bedroom.
Select the mode on the TV for “Line In” (AV, EXT or channel 0). You can
take the remote of your Satellite Receiver to your bedroom to control your
TV channels tuned in your Satellite Receiver.
Getting Started
SV-1730_21T_RDN-1031111_SV_1715_AV_Sender 17 talen 03-11-11 10:04 Pagina 6