Pavement Ends 44587 Flip Top - Manual (Page 7)

44587 pg 7 Rev. H 1210
Step Nine
I NSTALL T OP TO H EADER
Pull the deck up over the center bow to the Windshield Header Assembly. Open the Sun Roof and stand inside the vehicle to
access the front of the assembly. Wrap the front edge of the Top Fabric around the front edge of the Windshield Header Assembly.
Make sure that the fabric is centered on the header by starting at the center and working your way out. Press the plastic retainer
along the front of the top into the channel on the header until it snaps into the channel. The ends of the plastic retainer extend
about 1/2" over each side.
Note: Make sure the plastic retainer is snapped fi rmly into the Header channel. The Sun Roof feature will not work properly if the
retainer is not securely installed.
Tip: if you have trouble with attaching the retainer, move the header assembly to a 90° angle and try again.
Wrap Fabric around
Windshield Header and
snap plastic retainer into
channel in header
View from inside top
Snap to bows
Bows
Step Ten
S NAP T OP TO B OWS
Drape the top over the rear of the vehicle and snap it to
the bows.
Note: Make sure the spreaderbars are in a lowered position.
This will ease installation.
Step Eleven
P
OSITION
F
RONT
B
OW
Push front support bow fi rmly all the way forward. The
clearance between the Sport Bar and Front Bow may
be tight.
Front
Front Support
Bow
Vertical
Rod
Sport Bar
Bow must slip
into notch in belt
rail