Pavement Ends 41826 Cargo Cover - Manual (Page 5)

41826 pg 5 0509 Rev. A
Step Three - Optional
Pull up on the front, reinforced edge of
the Cargo Cover and mark the locations
matching the three snaps on the Cab
Curtain fl ap, on the doubled fabric along
the top of the Cargo Cover.
Snaps - on underside of fl ap
Install Studs on Fabric
Reinforced Front Edge of
Cargo Cover
Step Four - Optional
At the marked locations, push the sharp
end of a Snap Head Screw through the
Cargo Cover at the marked locations, to
make a hole. Once a hole is formed, pull
the screw back out of the hole. Then push
the screw through the hole from the vinyl
side so that the snap is on top of the vinyl.
Thread an Acorn Locknut over the pointed
end of the Snap Head Screw. Snap
the Cargo Cover and the Cab Curtain
together with the three snaps.
Cargo Cover Fabric -
Backing Up
Doubled Fabric Push Snap Head Screw
through to form a hole
Cargo Cover
Fabric - Vinyl Up
Acorn Locknut
Snap Head
Screw
If You Have a New Cab Curtain on Your Vehicle
Optional Installation
Cargo Cover
Pull Flap out and
Over Cargo Cover
Cab Curtain - From
Rear
Step Two - Optional
Locate the fl ap sewn to the vinyl
side of the Cab Curtain. Pull the fl ap
out over the top of the front edge of
the Cargo Cover.
Step One - Optional
Locate Attaching Snaps from
Hardware Kit supplied with the Cab
Curtain.