Pavement Ends 43920 Front Bumpers - Manual (Page 2)

43920 pg 2 0311 Rev. C
Parts List
Step One
R EMOVE THE O RIGINAL B UMPER
Use a socket wrench with an T55 Torx Socket to remove the two (2)
bolts on the top of the bumper on each side, four (4) bolts altogether.
When these are removed, use a 19mm socket to remove the bolt
underneath the bumper on each side. Remove the 15mm hex bolt
on each side. Set these bolts aside to be used to install the Front
Bumper.
Step Three
I NSTALL W INCH P LATE
Set the Winch Plate on top of the vehicle frame. Use
the remaining Washers and reinstall the hardware
that was removed in Step 1.
Tools Needed
Ratchet
15mm and 19mm Sockets
T55 Torx Socket
3/16" Allen Wrenches
Safety Glasses
Winch Plate, Part
Number 481.41, Qty - 1
Two or more
people may be
required to lift the bumper safely.
Bumper
Remove 19mm
Bolt
Remove Torx
Bolts
Bumper
Washer, Part Number
485.60, Qty - 4
Installation of Winch Plate Only
Remove 15mm
Hex Bolt
Reinstall 15mm
Hex Bolt
Winch
Plate
Reinstall Torx Bolts
with Washers
Make sure Winch Plate
is over bracket
Step Two
P
LACE
W
ASHERS
Place a Washer over each of the holes
for the Torx Bolts to act as a spacer.
Place Washers
over holes.
3/8", Part Number
481.43, Qty - 4
Used for Winch Installation