Penpower WorldPenScan (Win) - Manual (Page 16)

2-9 Chapter 2 Getting Started
8. Then, the pen scanner will connect to your PC automatically. When pen scanner is
paired with your PC successfully, the status light on pen scanner blinks slowly (blink
every 3 seconds), and the pen scanner will connect with WorldPenScan BT automati-
cally. You can begin to use WorldPenScan BT when the pen bluetooth status changed
to [Paired and connected].
Note 1: Long press the function button on pen scanner will turn off pen scanner. Next
time you want to use WorldPenScan BT, please shortly press function button to
turn on pen scanner. The pen scanner will connect to WorldPenScan BT soft-
ware automatically. There is no need to pair your computer and pen scanner
again.
Note 2: If your computer has paired with pen scanner but cannot to connect to pen
scanner for use, you can go to [Start\Control Panel\Printers and Other Hard-
ware\Bluetooth Devices ] to remove [WorldPenScan] and follow the instruc-
tions to pair your computer and pen scanne r again.
Note 4: If pen scanner is not connected with the software nor executed more than 10
minutes, or is connected with the software but not executed more than 30 min-
utes, the pen scanner will automatically shut down to save power.
Note 3: For WorldPenScan BT, you can connect pen scanner with computer via USB
cable and via Bluetooth at the same time. Follow the instructions to connect
pen scanner with USB cable first, and enter the default passkey of pen scan-
ner: 1234 in the Add Bluetooth Device Wizard directly, the pen scanner will
connect to your computer automatically via Bluetooth. Now if you unplug the
USB cable, you can continue to use pen scanner via Bluetooth.