Bissell FLIP-IT 5200 - Manual (Page 9)

9
WARNING:
To reduce the risk of
fire, electric shock or
injury unplug from outlet
before servicing.
While Wet Cleaning, you will see dirty water
collected in the Dirty Tank. When the Tank is full, the
white Float in the Dirty Tank will rise to the top,
making a noticeable sound to let you know it is time to
empty the Dirty Tank.
Remove the Dirty Tank Lid. Then dump the dirty water and
debris into the sink, toilet, laundry tub or outside. Rinse the
tank out with warm water and replace it in the unit.
While the Dirty Tank is out of the unit, remove the
Pleated Filter from the top of the tank. Remove dirt and
debris from the pleats by gently tapping the filter over
the wastebasket or outside.
Remove dirt and debris from the pleats by gently tapping
the filter over the wastebasket or outside. The Pleated
Filter can also be rinsed under water to clean.
NOTE: If the Pleated Filter is rinsed with warm
water to clean, it is recommended to leave it out of
the unit to air dry before placing it back in the unit.
Gentle Clean™Brush
Remove the Brush from the unit and rinse under
warm water.
Gentle Clean™Pad
Remove the Gentle Clean™ Pad Plate from the unit. Peel
the pad from the Pad Plate and toss in the wash!
Remove the Wet Cleaning Nozzle by pulling tab on right
side of nozzle. Rinse any dirt and grime off the nozzle
under warm tap water.
To replace the Wet Cleaning Nozzle, insert the 4 tabs
along the bottom of the Nozzle Window First and gently
snap the Wet Cleaning Nozzle back into place.
Checking The Filter
Tip:
If there are large pieces of
debris in the water, you may
not want to empty the tank
into your sink.
When You're Finished
Emptying the Dirty Tank
Cleaning The Gentle Clean™ Brush or Pad
Removing Wet Cleaning Nozzle
Tip:
While using the Flip-It in the
Wet Cleaning mode, make
sure to listen for the change
in the sound to alert you
when the Dirty Tank is full.
Dirty Tank Is Full