Pololu USB AVR User Manual
Page 26
AVR Studio 4’s programmer-selection dialog
If the ISP window does not appear when you click “Connect…”, your computer cannot detect the programmer.
Please see Troubleshooting (
) for help identifying and fixing the problem.
If AVR Studio brings up a dialog asking if you want to upgrade (or downgrade) your programmer’s firmware,
click Cancel to ignore the message and use your programmer. To prevent this dialog from appearing in the
future, use the Configuration Utility (
) to change the programmer’s hardware and software version
numbers.
6.
Select the Main tab. In the dropdown box that lists AVR models, select the same device that you selected
when you created the project. For an Orangutan or 3pi Robot, this will either be ATmega48, ATmega168, or
ATmega328P.
Selecting the device for ISP programming in AVR Studio
7.
If you have not done so already, connect the programmer to the target device using the 6-pin ISP cable. Make
sure the cable is oriented so that pin 1 on the connector lines up with pin 1 on your target device! You can
Pololu USB AVR Programmer User's Guide
© 2001–2014 Pololu Corporation
3. Getting Started in Windows
Page 26 of 54