Precision Turbo and Engine BigStuff3 GEN3 Powertrain Controller Transmission Control Users Manual - Manual (Page 21)

Bigstuff3 GEN3 Transmission Control Manual
Save a Dash
Again, the recommended way to configure the “Default Dash” is to configure each of available dash’s,
or most frequently used dash’s, to your liking and then save them as the “Default Dash”.
This way, every time you open the BigComm software, the dash’s will be open to the preferred
configuration.
Once the “Default Dash” has been saved, individual dash’s can be changed and saved again as part of
the compilation of dash’s referred to as the “Default Dash”.
The steps for saving a reconfigured Dash, so that it becomes part of the “Default Dash”, are outlined
below:
• After configuring a Dash hit OK at the bottom of the Dash Setup window. The window
will close.
• Go back to Dash on the Main Window tool bar and Select Save To File from the Dash drop
down list. The screen below will open
Note: Before saving the Shift or TCC dash’s for the first time, you need to navigate
to the C: Program Files/BigStuff/BigComm directory. This step only occurs the
very first time any Dash file is saved. Subsequent Dash file saves will automatically
be saved to the C: Program Files/BigStuff/BigComm folder.
• Name the file “Default” and hit Save. By selecting “Default” as the file name, the Log
Window dash becomes part of the compilation called “Default Dash”. Again, the file will
be saved to C:/Program Files/BigStuff/BigComm directory.
21