Precisionsound Gospel Drawbars - Manual (Page 6)

6
© Copyright Precisionsound 2013 www.precisionsound.net
Tone page
On the Tone page, you can adjust the frequency and stereo image of the sound. From left to right, the
controls are:
EQ
Lo: sets the volume of low frequencies, between +/-6 decibels.
Mid: sets the volume of mid frequencies, between +/-6 decibels.
Hi: sets the volume of high frequencies, between +/-6 decibels.
The EQ frequencies have been pre-tweaked by Precisionsound to suit the Gospel Drawbars instrument.
Stereo
Width: sets the stereo width of the organ samples, where 0% = mono, and 100% = natural stereo.
Because we sampled the organ in stereo through its Leslie speaker, the sound includes the natural
chorale effect (slow rotary speaker), which is great in itself. However, a possible drawback is that a non-
desired cross modulation effect may occur when using Kontakt’s Rotator effect (or third party
alternatives) to achieve the fast speed of the rotor. To reduce this, we recommend that you set Width to
mono when using a rotary speaker simulator.
Rotator
Speed: sets the speed of the rotating speaker simulation, slow or fast. This dial is linked to the
modulation wheel (MIDI CC1), so that raising the wheel from 0 to 127 changes the rotator speed from
slow to fast, and vice versa.
Rotator on/off: enables or disables the rotating speaker simulation.