MacDon D65 - Manual (Page 14)

ELECTRICAL
169784 12 Revision A
STEP 3. INSTALL HEADER
ELECTRICAL HARNESS
a. Remove cap on connector (A) and cut cable
tie (B).
b. Route the connector (C) and wiring harness (D)
under leg to the axle and through bracket (E).
c. Position clip (F) and connector (C) inside bracket
(E) and attach clip to bracket with two 1/4 in.
x0.5 lg. self-tapping screws (G).
d. Secure wiring harness to axle with holder (H) and
two 3/8”x0.625 lg. self-tapping screws (J). If
necessary, loosen clamp inside leg and adjust
harness length as required.
C
F
G
D
E
C
TIP
Install and remove self-tapping screws
before attaching holder.
O
P
C
A
B
D