Brother DCP9040CN - Manual (Page 51)

43
B
B
Memory board
B
This machine has 64 MB of standard memory
and one slot for optional memory expansion.
You can expand the memory up to 576 MB by
installing 144 pin small outline dual in-line
memory modules (SO-DIMMs). When you
add the optional memory, it increases the
performance for both copy and print
operations.
In general, the machine uses
industry-standard SO-DIMM with the
following specifications:
Type: 144 pin and 64 bit output
CAS latency: 2
Clock frequency: 100 MHz or more
Capacity: 64, 128, 256 or 512 MB
Height: 31.75 mm
Dram Type: SDRAM 2 Bank
For purchasing information and part numbers
visit the Buffalo Technology website:
http://www.buffalo-technology.com/
Note
• There might be some SO-DIMMs that will
not work with the machine.
• For more information, call the dealer you
bought the machine from.
Installing extra memory
B
a
Turn off the machine’s power switch.
b
Disconnect the interface cable from the
machine, and then unplug the power
cord from the electrical socket.
c
Remove the DIMM covers (1 and 2).
d
Unpack the DIMM and hold it by its
edges.
CAUTION
To prevent damage to the machine from
static electricity, DO NOT touch the
memory chips or the board surface.
e
Hold the DIMM by the edges and align
the notches in the DIMM with the
protrusions in the slot. Insert the DIMM
diagonally (1), then tilt it toward the
interface board until it clicks into
place (2).
Optional memory
B
2
1
1 2