Instruction sheet, Prs.4tec – Prescolite TL-42 User Manual
Page 2
www.prescolite.com
• Prescolite
TollFree
Technical
Support
1.888.PRS.4TEC
•
Hours:
8am
- 5pm
ET
701 Millennium Blvd., • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright 2014, 4/9/14 revision, All Rights Reserved - Printed in U.S.A.
Part No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 05395600
Instruction
Sheet
Reflector
Spring Clip (2)
Plaster Flange
Torsion Spring Bracket
Torsion Spring
Fig. 4
1. Assemble the socket from the LiteBox
®
housing into the mounting hole
in the side of the reflector.
2. Install the reflector in the LiteBox
®
aperture by placing the notches in
the spring clips on the housing plaster flange. (See Fig. 2)
IMPORTANT - MAKE SURE TO POSITION THE SOCKET IN THE
CORNER OPPOSITE THE WIREWAY IN THE LITEBOX
®
HOUSING.
3. Install the lamp.
4. Place the lens in the recess of the trim flange. (Use care not to drop
the lens as it not mechanically retained)
5. To install the trim flange into the LiteBox
®
housing, squeeze the torsion
spring legs together and place into the torsion springbrackets in the
LiteBox
®
housing. (See Fig. 3) Push the trim up and allow the torsion
springs to pull the trim flange up against the ceiling.
Fig. 2