Retsch SR 200 - Manual (Page 10)

2/8/2012

Retsch GmbH
10
0002
8
9
1
2
3
4
5
6
7
Fig.2
Fig.3
We recommend that the SR 200 be mounted on an
underframe, which can be supplied as an accessory. Fig.2
Mounting:
* Connect centre cross-piece 9 base side pieces 8 using the
cylinder-head screws 1
* Push covering caps 2 onto the projecting thread
* Place stand tube 3 in the sleeve 4 and fasten tight with the
headless screws 5
* If necessary, the underframe can be aligned using the
cylinder-head screws 6
So as to be able to fasten the underframe with screws,
maximum diam. 10mm possible, to the ground, the two setting
screws 6 and the front plastic caps 7 must be removed.
* Place SR 200 on the underframe Fig.3
* To fasten hexagon-head bolts SCH M8x35 supplied with
the underframe, use spring washers and hexagon nuts