Retsch TWISTER - Manual (Page 30)

Operating the machine
30

Pos : 7. 46 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 Aust ausc h der Ger ät esic her ung @ 0\ mod_1227260127023_9.doc @ 3952 @ @ 1
5.18 Replacing the machine fuses
Pos : 7. 47 /00010 Bedi enungsanleit ung en Kapitels ammlung en/ GM200 (2010)/ 0015 GM200N Bedienung/ 1597 GM 200_2010_TM 100_ Modul Aust ausc h der Ger ät esic her ung @ 3\ mod_1279722531841_9.doc @ 21802 @ @ 1
Fig. 1: Replacing the device fuse
The following glass fuses are required:
220V - 240V  2 x TT6,3 A
100V - 120V  2 x TT12,5 A
• Pull the plug out of the device socket (M).
• Push in the side catch (MA). This unlocks the fuse holder (L) which can
then be pulled out.
• Always replace both fuses.
• Slide the fuse holder (L) in until it engages.
Pos : 7. 48 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 Überlas tsic her ung z urüc ks etz en @ 3\ mod_1279719797635_9. doc @ 21533 @ @ 1
5.19 Resetting the overload protection
Pos : 7. 49 /00010 Bedi enungsanleit ung en Kapitels ammlungen/ GM200 (2010)/ 0015 GM200N Bedienung/ 1598 GM 200_2010_TM 100_M odul Ü berlast si cherung z urüc ksetzen @ 3\ mod_1279722532575_9.doc @ 21811 @ @ 1
The overload protection switch (K) is situated on the rear panel.
This overload protection switch disconnects the device from the power supply if the
machine is overloaded.
• After allowing the device to cool down it can be used with the power supply
again by pressing the overload protection switch (K).
Fig. 23: Overload protection switch
Pos : 8 / 00010 Bedienungsanlei tungen Kapit elsamml ung en/------- Seitenumbr uch ----------- @ 0\ mod_1222344373758_0. doc @ 2386 @ @ 1
K
L
M
MA