RKI Instruments FP-40 - Manual (Page 4)

3
1.2 Installation of Detection Tab
The detection TAB comes packaged in a sealed foil wrapper. Remove it from the wrapper. The detection
surface of the TAB is protected by a plastic cover that fits over the TAB. Remove this cover. The
detection TAB must only be handled by its edges or backside. Do not touch the indented center section
of the TAB.
1. Open the detection TAB cover.
2. Place the TAB into the slot under the cover, indented face down, and then close the cover
slowly.
3. Press the center of detection TAB cover with finger to assure proper TAB seating.
Lift up this way.
Detection TAB cover
Instrument (Side view)
Close the cover.
Detection TAB
Instrument (Side view)
When closing the detection TAB cover, close it slowly to avoid pinching finger.
Do not allow the lid to slam shut since that may cause damage to the
instrument.
When installing the detection TAB, do not allow water drops or dust to get in
the TAB port area.