RKI Instruments 49-8104RK - Manual (Page 10)

10 • 49-8104RK Standby Battery
Figure 6: Wiring the Standby Battery to a Beacon 800
11. Turn on power to the controller.
12. Turn on the controller.
13. When the controller has completed its startup sequence, re-connect the end of the
jumper wire to the battery terminal from which it was removed.
14. Close the standby battery housing door.
15. The on/off switch in the Beacon 200, Beacon 410, and Beacon 800 controls AC power
to the instruments. Verify that the standby battery is installed properly by flipping the
on/off switch to the off position and observing that the controller continues to operate
powered by the standby battery.
16. Flip the controller power switch to the on position.
Connections
Made With Wire
Nuts Provided
NC
NO
BAT+
AL
M
2
NO
C
C
NO
NC
RX
GND
+28V
TX
RESET
BUZ +
BUZ
RESET
BAT
FA
IL
A
L
M
1
Beacon 800 Housing
User
Installed
Jumper
Controller Terminal Strip
24
VD
C
Standby Battery Shown Without Door
C
NC