RKI Instruments 1017-03 - Manual (Page 10)

6 • Model 1017-03 Operator’s Manual
CAUTION: Do not route controller power and detector wiring through the same conduit hub.
The power cable may disrupt the transmission of the detector signal to the controller.
9. Connect the detector wires to the applicable controller terminal strip. See the
controller operator’s manual and the controller’s detector head specification sheet for
the Model 1017-03.
10. If using shielded cable, connect the cable’s drain wire to an available chassis ground at
the controller. RKI controllers typically have a ground stud that is a convenient
grounding location.
Figure 4: Wiring the Model 1017-03
To Sensor Terminal s
at Controller
Input Power
Terminal Strip
Terminal Plate
Model 1017 Housing
+
24 VDC
R
W
G
B
Sensor Terminal
Strip