RKI Instruments 35-3000RK-LEL/O - Manual (Page 11)

35-3000RK-LEL/O Sample-Draw Detector • 7
Installation
This section describes procedures to mount the sample-draw detector in the monitoring
environment and wire the sample-draw detector to a controller.
Mounting the Sample-Draw Detector
1. Select the mounting site. Consider the following when you select the mounting site.
• Is there enough room to open the housing door and make wiring connections at
the bottom of the housing and tubing connections at the right of the housing?
• Make sure there is sufficient room to perform start-up, maintenance, and
calibration procedures.
• Are the flowmeter and status lights visible?
Figure 3: Mounting the Sample-Draw Detector
4. Close and latch the housing door.
NOTE: The sample-draw detector is shipped with the mounting feet “tucked under” the
housing to protect the mounting feet during shipment.
6.5 in.
4.0 in.
Note: The housing is 4.25 in. deep.
8.5
in.
9.3
in.
8.9
in.
3/4 in. conduit hub
(total of 2 hubs)
7.3 in.