RKI Instruments 35-3010RK-05 - Manual (Page 24)

20 • 35-3010RK-05 Sample-Draw Detector
NOTE: For convenience, leave the regulator connected to the sample tubing.
Returning to Normal Operation
1. Remove the voltmeter leads from the test points.
2. Reconnect the incoming sample line.
3. Wait 1 to 2 minutes to allow the calibration gas to be drawn out and the reading to
stabilize.
4. Close the housing door.
5. Store the components of the calibration kit in a safe and convenient place.
Parts List
Table 2 lists replacement parts and accessories for the sample draw gas detector.
Table 2: Parts List
Part Number Description
06-1248RK Sample tubing, 3/16 x 5/16, specify length, (for calibration kit)
07-0034RK Sealing gasket for CO flow block cavity
30-0610RK Pump
33-0171RK Hydrophobic filter (AcroPak)
33-6095RK Charcoal filter, CF-188
65-0601RK Oxygen sensor
81-0076RK-01 Zero air calibration cylinder (34 liter)
81-0090RK-01 3-gas calibration gas cylinder, 50% LEL methane/12% oxygen/50
ppm CO, 34 liter
81-0155RK Regulator, demand flow, for 17 and 34 liter steel cylinders
ES-1531-CO CO sensor