Start up, Introducing incoming power, Black – RKI Instruments 65-2336RK User Manual
Page 11
65-2336RK CO Transmitter • 7
Figure 4: Wiring the CO Transmitter to a Controller
12. If shielded cable is used, connect the cable’s drain wire to an available chassis (earth)
ground at the controller. RKI controllers typically have a ground stud that can be used
to ground the cable’s drain wire.
Start Up
This section describes procedures to start up the CO transmitter and place the transmitter
into normal operation.
Introducing Incoming Power
1.
Complete the installation procedures described earlier in this manual.
2.
Verify that the power wiring to the controller is correct and secure. Refer to the
controller operator’s manual.
3.
Turn on power to the controller.
4.
Turn on the controller.
T
O
X
IC
O
X
Y
S
SI
G
/P
W
R
Red
SP
A
N
ZE
R
O
Controller Detector/Transmitter
Terminals, Typical Designations
Cable Shield
J-Box
Controller Housing
Black
CO Detector
+
S