S&S Cycle All-Helical Transmission Complete Assembly for 1991-99 Harley-Davidson Softail and Custom Applications - Manual (Page 5)

8- Support the rear of the motorcycle with a scissors jack and then loosen the front mounting bolts on the shocks as shown in Picture 1.
This will allow you to access the transmission mounting bolts and remove them. Lift the old transmission out once the mounting
hardware is removed.
For further information, refer to your factory service manual.
INSTALLATION
1- Prior to placing the transmission in the chassis, verify that the mounting plate is clean and free from any debris or paint chips. Install
the transmission onto the mounting plate (See Picture 2) and thread your existing hardware on the five mounting studs. See
Picture 3.
5
Picture 1
Picture 2 Picture 3
NOTE: Stock Harley-Davidson ® frames have a removable transmission mounting plate, that will need to be transferred to the new
S&S ® transmission for installation as an assembly in the frame. Please refer to the factory service manual for your model motorcycle.
NOTE: Stock Harley-Davidson ® frames have a removable transmission mounting plate, that will need to be transferred to the new S&S
transmission for installation as an assembly in the frame. Please refer to the factory service manual for your model motorcycle.