S&S Cycle Chain Drive Camshaft for 2007-Up Big Twin and 2006-Up Harley-Davidson Dyna User Manual
Page 4
4
2- Remove cam cover and gasket. Secure lifters with a tool made from a large binder clip spring. See Picture 2.
3- Rotate rear wheel to align timing marks on the primary cam chain.
4- Remove the primary chain tensioner by removing the two retaining bolts and install sprocket locking tool.
5- Remove the crank sprocket bolt and flat washer.
6- Remove rear cam sprocket bolt and flat washer.
7- Remove sprocket locking tool.
8- Gently pry off crank sprocket and rear cam sprocket.
Cam Support Plate and Cam Removal
1- Gradually loosen and remove the four oil pump bolts/washers according to the sequence shown below.
2- Gradually loosen and remove the six support plate bolts/washers according to the sequence shown below.
3- Remove spacer from rear cam, this spacer is thicker than the front spacer.
4- Remove cam plate and cams from engine.
5- Remove retaining ring and spacer from front cam. This spacer is 0.100” thick.
6- Remove the secondary cam chain tensioner.
7- Remove the cams and cam chain. Mark the direction of the cam chain so that it is installed in the original direction of rotation with the
new cams.
Picture 4
1
1
3
2
4
4
2
6
3
5
Picture 2
Picture 3
Grind points
on each end