S&S Cycle Clutch Removal and Inner Primary Bearing Race Removal Tool PN 56-5141 - Manual (Page 3)


7
5
6
3
4
REPLACEMENT PARTS FOR S&S CLUTCh REMOVAL AND INNER PRIMARY BEARINg RACE REMOVAL TOOL PN 56-5141
1. Cap screw (10 pack) . . . . . . . . . . . 50-0382
2. Nut, hex (10 pack). . . . . . . . . . . . . 50-0384
3. Plate, race puller
. . . . . . . . . . . . . . 56-5138
4. Head, puller . . . . . . . . . . . . . . . . 56-5135
5. Bearing kit, clutch tool
. . . . . . 56-1232
6. Head, inter, puller . . . . . . . . . . . 56-5136
7. Retaining ring (10 pack) . . . . . . . 56-8347
8. Plate, puller. . . . . . . . . . . . . . . . . 56-5134
9. Screw, puller. . . . . . . . . . . . . . . . 50-0381
USE OF S&S® SERVICE TOOL 56-5141 FOR REMOVINg INNER PRIMARY BEARINg RACE
Disconnect the negative battery cable before performing any primary drive or clutch work on your motorcycle to prevent personal injury.
NOTE: Threads of the puller screw should be coated with a graphite lube to protect threads.
The use of power tools can severely damage S&S clutch and inner primary bearing race service tool.
1. Drain and remove outer primary cover, internal primary components, and inner primary housing following your factory service manual.
2. Place the inner bearing race puller, U-shaped assembly, through the clutch puller plate.
3. Slide the “U” shaped race puller plate behind the inner bearing race. See Picture 3.
WARNING
CAUTION
Picture 3
4. Using a 3/8” ratchet, or breaker bar, and a ¾” wrench, remove the inner bearing race from the transmission mainshaft.
8
9
1
2