S&S Cycle Replacing Data Link Connector Plug Used In SSW+ Ignition Kit 55-1050 - Manual

Early shipments of S&S part #55-1050 SSW+ Ignition Installation Kit were shipped with a rubber data port connector
plug that does not insulate sufficiently, allowing a slight electric current flow between the connector pins. The original
plug could cause the ignition to use more electricity than normal, and could also cause the MIL (Malfunction Indicator
Lamp) to flash in an erratic fashion.
See Picture 1 to identify data port connector and plug. If the installation kit has a rubber data plug with no part number
on it, it should be discarded and replaced with a new plug. The correct replacement plug supplied by S&S will have
either #55-1022-S, or #72164-94 molded into the plug.
A replacement plug can be obtained from S&S by calling the Technical Department at 608-627-8324.
Service Bulletin #51-1159
2-27-03
Copyright®, 2003
by S&S Cycle, Inc.
All rights reserved. Printed in the U.S.A. Because every industry has a leader
S&S Cycle, Inc.
14025 County Highway G Box 215
Viola, Wisconsin 54664
Phone: 608-627-2080 • Fax: 608-627-1488
Technical Service Phone: 608-627-TECH (8324)
Technical Service Email: [email protected]
Website: www.sscycle.com
Replacing Data Link Connector Plug
Used In SSW+ Ignition Installation Kit #55-1050
S&S Service Bulletin
Picture 1