S&S Cycle Super Stock C Ignition in Carbureted, 2004–2007 American Ironhorse Motorcycles - Manual (Page 2)

2
A. Introduction
The S&S Super Stock® C is a reliable replacement for the stock ignition module found on 2004–2007 American IronHorse® Motorcycles. Note
that the unit is designed to work with the stock tachometer and coils. If the motorcycle is fitted with aftermarket components not designed for
this application (2004–2007 carbureted AIH motorcycles) the Super Stock C may not function properly.
Installation of this module requires modification of the stock harness. If you are not comfortable with performing motorcycle electrical work or
do not have the proper tools, we suggest locating a shop that can perform this work. Also, to install this kit, you will need to obtain the correct
components to mate the module to the wiring harness. These can be obtained from most Harley-Davidson® dealerships or shops specializing in
Harley-Davidson electrical work.
If you are not familiar with the Deutsch® connector required for the installation of the Super Stock C, we recommend that you review the relevant
section in a later model Harley-Davidson Electrical Diagnostic manual (for example, 2004 Touring Electrical Diagnostic Manual).
This unit may be used with carbon core or spiral core spark plug wires. Do not use solid copper spark plug wires or non-resistor plugs. This may
cause the unit to misfire.
Kit Contents
• Super Stock C Ignition Module
Additional Parts Required
• Deutsch® Black, 12-Socket DT Plug (H-D® P/N: 72119-94BK, Qty: 1)
• Deutsch DT Socket Locking Wedge (H-D P/N: 72159-94, Qty: 1)
• Deutsch DT Terminal Socket (H-D P/N: 72191-94, Qty: 9 (2004 Models), Qty: 10 (2005–2007 Models))
• Deutsch DT Seal Pin (H-D P/N: 72195-94, Qty: 3 (2004 Models), Qty: 2 (2005–2007 Models))
Optional Tools
As mentioned in the introduction, it is recommended that you have access to the proper tools for this installation. If you do not have Deutsch
crimpers, MSD Ignition® sells an economic solution for properly crimping the terminals:
• MSD Pro-Crimp Tool II (P/N: MSD-35051)
• MSD Deutsch Terminal Dies (P/N: MSD-3510)
The Super Stock C is not compatible with the S&S Super Stock diagnostic cable and software (Operating Statistics and S&S Ignition
Configuration). Do not attempt to use these tools with the Super Stock C ignition.
American IronHorse® 2004 Model Installation
1. Be sure that ignition switch is off and disconnect battery.
2. Remove stock ignition module
3. Remove the stock ignition module connector by cutting the wires as close as possible to the connector.
4. Strip the wire ends and crimp the Deutsch socket terminals on the wires.
5. Install the socket terminals into the Deutsch connector according to the wiring diagram shown in Figure 1, next page.
6. Install seal pins into unused positions and locking wedge on Deutsch connector.
7. Install Super Stock C and reconnect battery.
Installation is now complete.
CAUTION