S&S Cycle Billet Air Cleaner Kit PN 106-1319 for Victory Motorcycles - Manual (Page 2)

2
KIT CONTENTS:
• Billet backplate
• Qty of 5 - M6 fasteners • Breather hose
• Billet top cover • Gasket • Qty of 4 - Hose clamps
• 243 Blue Loctite® • Straight breather fi tting • Wire tie
• Calibration Card • Filter Element
SPECIAL TOOL REQUIREMENTS
• PVC Pipe Wire Saw – Available from your local hardware store
• S&S® Freedom® Performance Tuner – Available to authorized S&S/Victory® Dealers.
• Smart Link Module Kit – PT# PU-47471 Available through Polaris® dealers
• Victory Service Manual – Available through Polaris dealers
The S&S® 106-1319 billet air cleaner kit is intended for all Victory® 2008 and up models except Vision™, Cross Country™, and Cross Roads™. This air
cleaner kit is intended to be used with Victory Stage I performance slip-on muffl ers or Victory Stage I performance exhaust systems.
Note: A list of EFI calibrations that are available for dealer downloading can be viewed on the S&S Cycle web site at www.sscycle.com go to the Technical
Info tab and click on Engine Control Software/Victory Calibrations.
The safety of the motorcycle rider is dependent on proper installation of this product. If you are not certain of your capabilities or do
•
not have the correct tools for this installation, please consult a dealer to have it done. Improper installation of this product could result
in injury or death to the rider.
Be sure to disconnect the battery of your motorcycle before starting on this procedure. Accidental starting of the motorcycle could cause
•
injury to you or others around you during the installation.
DISASSEMBLY
Seat and Gas Tank Removal
1 – Disconnect the negative battery cable from the motorcycle and route it away from any metal parts in the area.
2 – Remove the seat and gas tank from the Victory motorcycle following your Victory service manual for the specifi c model you are performing
the work on.
Picture 1
WARNING